Skip to main content
Topic: Starting fresh (Read 2042 times) previous topic - next topic

Re: Starting fresh

Reply #135
Couple more

Re: Starting fresh

Reply #136
And now its done

Re: Starting fresh

Reply #137
Looks great! How much of a handling improvement do you feel on the street?

I'm not sure the bar would clear the 2.5" tailpipes I'm running, especially on the passenger side. It would be extremely tight if it fit at all.
88 Thunderbird LX: 306, Edelbrock Performer heads, Comp 266HR cam, Edelbrock Performer RPM intake, bunch of other stuff.

Re: Starting fresh

Reply #138
I'll have to get back with you on that one, I didn't put a ton of drive time on it. I put a couple miles on it but. Not enough to really open it up. Just enough to see that is doesn't bind any.

As for tail pipes, thats a big hell no. Driver side will fit no problem. Passenger side will require some major magic with a mandrel bender. It could go up over the axle and immediately make a 90* bend the almost immediately make another then out the back. That's just to much for me. And with the tires I have in the rear its stupid close anyway. Entirely not worth it. I may later down the road when I get tired of my mac mufflers or when I build the next motor and step up the exhaust to 3" go the way of side exit in front of the rear tire but dumps work for now

Edit: I also still have to put the sway bar on. Then the suspension will be completely done. Aside from some camber tweaks. Cause the guy that did my alignment put smaller bolts in the upper strut mount holes to get more camber put of it before realizing I had cc plates. So the inside of the front right tire is rubbing the coilovers something fierce after the suspension settled more

Re: Starting fresh

Reply #139
I strongly suggest you get where the panhard bar is attached to the frame welded. If you get stupid with it they will start to wobble the holes out. Mine is welded for that reason.

83 351W TKO'd T-Bird on the bottle


93 331 Mustang coupe that beat your mom's LTD

 

Re: Starting fresh

Reply #140
No real progress to speak of, I got to find a better ground spot for my battery and figure out why the 3g alt isn't charging. I wired it the same way I did on the old car. I havent taken the alt in to be tested yet either. Its been a pretty busy week with barely any time to work on the car. I'm prepping for the October 5th track day at Muncie I should have everything sorted out by then.

Re: Starting fresh

Reply #141
Well I found out why the 3g wasn't charging. Apparently it just gave up. It was like 13 years old so no big deal. Got the new one in and the rear ride height bumped up a little now so the quarter lips wont eat the tires so bad.  I'll need to roll them soon especially if I run my slicks.

Re: Starting fresh

Reply #142
Are the slicks mounted on Town Car wheels?
88 Thunderbird LX: 306, Edelbrock Performer heads, Comp 266HR cam, Edelbrock Performer RPM intake, bunch of other stuff.