Skip to main content

Show Posts

This section allows you to view all Show Posts made by this member. Note that you can only see Show Posts made in areas you currently have access to.

Messages - Mikey97D

2
Electrical Tech / Re: Fuel Pump Runs Intermittently
Got it started and set the timing.  Let it sit a few hours then took it on short trip around town.  Hasn't died.......yet.

Realizing now I probably should have posted this in electrical.
3
Engine Tech / Re: 3.8L Mechanical Fuel Pump interchangeability ?
I am not familiar enough with the 3.8 to know if it's similar to the Windsor motors that have it on the timing cover.  I just double checked on 351 on the stand.

Looking through the '88 shop manual it appears there is a timing cover and Google searching '83 3.8 shows the fuel pump on the passenger side on the front but not sure if it is on the cover but would make sense.
5
Electrical Tech / Re: Fuel Pump Runs Intermittently
At this point in time, I am thinking of removing that plug because it is garbage and jumping the wires together until I find a replacement plug and inertia switch. 

I can see if the fuel pump continues to run while the car warms up and if it loses power then it is either the relay or pip?
7
Electrical Tech / Fuel Pump Runs Intermittently
'88 Thunderbird TC

About a month or so ago I thought my fuel pump went bad so I replaced it with a Walbro 255 lph that I had waiting to install.  Ran fine for a few hundred miles until yesterday 1/2 mile from home.

Replaced the TFI cause it was erratic on running / not running yesterday.  Thought I was gonna need a tow but it started and ran perfect to get it home.

I tried to warm the car up to set the timing after replacing the TFI (It's easier to remove the distributor to change TFI on the 2.3).  Runs for a few minutes and dies.  Timing light is flashing so I know I have spark.  Fuel pump does prime when i turn the ignition on for starting.  Doesn't prime every time I cycle the key back to back. 

I get the car to run for a few moments to see the fuel pressure at 35 psi at idle then drop and the car dies.

I found the inertia switch and the white button is floppy.  Doesn't seem to do anything either direction. 

The intermittent thing has me thinking it isn't the inertia switch, but not sure.  Should the button be floppy on the switch?
What next to check?

Thank you in advance.
9
User Rides / Re: Starting fresh
Bummer on the starter and glad you were able to get the fire out.  Did the starter stick or the solenoid? 
11
User Rides / Re: Work In Progress. '88 TC
I got the tank back in the car Friday and everything buttoned up.  So far so good.

I didn't find any cracks in the rubber line on the pump in the tank, but replaced it anyhow for good measure.

Going on vacation in a couple weeks so prepping for that not sure when I will get back into the car for the covers and front spoiler.
13
User Rides / Re: Work In Progress. '88 TC
Are you sure its the fuel pump and not the piece of rubber between the fuel pump and the pickup assembly?  They rot out and crack causing fuel pump fail symptoms.  Cannot remember if you have already had the tank out and what not but thought I would throw it out there.
I am not certain. Thanks for the tip and I will check while I have the tank and pump out.  
Picked a syphon up today to start emptying the tank although with all this rain nothing is going to happen unfortunately because I am working in my driveway this time.
14
User Rides / Re: Work In Progress. '88 TC






Post edited for links / images

The slot for the hood hinge needs to be widened so the  middle SR Fab piece can fit flat.   There is a gap at the front of the sheets and the nose.  Not too bad though.
15
User Rides / Re: Work In Progress. '88 TC
The priority list changed last night.......Fuel Pump to the top of the list after it died!!!

I went to a cruise in last night where the engine just shut off as I was pulling in.  After trying to restart, I popped the hood to check the fuel pressure with the ignition on that read zero.  Cycled the key a few times to hear the pump whine and got it to start so i could get into a parking spot and rechecked the fuel pressure where it showed about 30-32 psi at idle.  The car needs to be cranked twice when starting cold of late and started pinging in 3rd gear recently so I have been driving it very mildly thinking I needed to do the plugs.  Kinda of an "Ah ha" moment. 

So relisted:
1. Fuel Pump
2. AFR gauge
then everything else.

Gumby & Chuck, Thanks for the tip on not blindly drilling the holes where marked.  Gumby, I like the idea of tucking the cover under the fender tab and the radiator brackets rather than drilling more holes.